Maintenance And Replacement Parts - Hunter TCX50 Operation Manual

Maintenance Schedule
Weekly
Periodically

6.2 Maintenance and Replacement Parts

Safety Goggles
Brush
Mounting Paste
Polymer Mount/Demount Head
Hand Held Bead Lever - straight
Bead Lever Protector Sleeve (HM)
Bead Lever Protector Sleeve (Std) (4)
High Grip Jaw Protection Kit (2 sets - 8 covers)
Steel Head Inserts (10 sets - 20 covers)
Clamping Jaw Extensions AR46 (4)
Operation Instructions for TCX50 Tire Charger
Daily
NAME
Perform the Following Maintenance
Drain condensation from pressure regulator
reservoir by pressing in on the fitting located on
the bottom of the regulator.
Check for worn or damaged rubber and nylon
components that should be replaced to prevent
damage from occurring. Replace worn parts as
needed (tool supports, rubber pads, lever protector
sleeve and mount/demount head).
Clean all areas that contact rims or tires to prevent
possible scratching to rim.
Clean tire changer with shop towels or a vacuum
cleaner. Do not clean with or use compressed
air, which can blast dirt between moving parts.
Do not use cleaning solvents to clean pressure
regulator and oiler (if present).
If present, refill oiler using only Hunter Lubri-Oil,
148-133-2, as needed. Petroleum-based oils
should never be used in the oiler and may void
all warranties. Adjust the oiler to release one drop
of oil every three rotations of the clamping table by
adjusting the screw on top.
Check for loose bolts and tighten per
specifications.
NUMBER
179-15-2
RP6-1506
RP6-3784
RP11-3314813
RP11-3009516
RP6-0326
RP11-8-11400098
RP11-8-11100358
RP11-8-11400096
RP11-8-11400276
63