Placing Wheel On Tire Changer; Clamping The Wheel From Inside Of Rim - Steel Rims - Hunter TCX56 Operating Instructions Manual

Release the "In" button to disengage the bead-breaker arm and press the "Out"
button to allow the bead breaker arm to open. If the bead has not completely
loosened, rotate the wheel and repeat the bead breaking procedure at a different
area on the tire.
Turn the wheel and break the opposite bead using the same procedure.

2.2 Placing Wheel on Tire Changer

Identify and recognize special wheel combinations such as Reverse Drop Center (needs
inverted on changer), AH, "Run-Flat" Extended Mobility Tires, and standard tires with
pressure sensors. If you are not fully familiar with these special wheel considerations, DO
NOT USE the tire changer. See your supervisor.

Clamping the Wheel from Inside of Rim - Steel Rims

Identify the inner locations on the rim where the clamps will come in contact.
Position the clamps in the fully retracted position (clamps completely in).
Place the wheel centered onto the turntable.
Step down
Avoid clamping inside rim of alloy wheels. Steel jaws may damage the finish of
inside rim surface during use.
Verify that the wheel has been properly clamped and centered.
Operation Instructions for TCX56/57 Tire Charger
on the clamping pedal to expand the clamps to the rim.
NOTICE
"In" button "Out" button
27