Hunter TCX56 Operating Instructions Manual page 58

Adjusting the Vertical Gap
1. Reposition the tool head on the rim and lock it in place with the head position lock.
2. If the gap is not correct, release the head position lock and adjust the nut beneath the
3. Reposition the tool head on the rim and lock it in place with the head position lock.
Adjusting the Horizontal Gap
1. Release the tool head, then reposition it on the rim and lock it in place with the head
2. Using a feeler gauge, check the horizontal gap between the tool head and the rim. The
58
Using a feeler gauge, check the distance between the tool head and the rim. The
distance should be .06 inch.
post locking system cover to adjust the gap. The cover must be removed. Back off
the nut to increase the gap and tighten to reduce the gap.
Re-check gap.
position lock.
distance should be 1/16 inch.
1/16 inch GAP
Operation Instructions for TCX56/57 Tire Charger
POST
LOCKING
SYSTEM
COVER
ADJUSTMENT
NUT