Hunter TCX56 Operating Instructions Manual page 57

2. Use the side adjustment screws to set the tool head perfectly horizontal in relation to
the rim.
3. The tool head should be touching the rim at the points shown below:
TOOL HEAD
TOUCH RIM AT
THIS POINT
4. Tighten the side adjustment screws, but not completely.
Radial Adjustment of the Tool Head
1. Release the tool head, then reposition it on the rim and lock it in place with the head
position lock.
2. Adjust the two front adjustment screws and set the tool head so the left side is
touching the rim and the right side is flush with the edge of the rim.
TOOL HEAD
SHOULD BE
FLUSH WITH
EDGE OF RIM
3. Fully tighten the adjustment screws starting with the head retaining bolt.
Release the post and reposition the tool head on the rim for gap adjustment.
Operation Instructions for TCX56/57 Tire Charger
SHOULD
ADJUSTMENT
SCREW
TOOL HEAD
SHOULD
TOUCH RIM AT
THIS POINT
TOOL HEAD
SHOULD
TOUCH RIM AT
THIS POINT
57