Mount/Demount Head Assembly; Mount/Demount Head Calibration - Hunter TCX56 Operating Instructions Manual

3.5 Mount/Demount Head Assembly

Mount/Demount Head Calibration

The mount/demount head is pre-calibrated from the factory, however, double
checking the calibration is recommended. Calibration requires the use of an
(approximately) 18 inch bare rim.
1. Clamp rim without a tire on the tire changer turntable.
2. Before making any adjustments, loosen the four adjustment screws and tighten the
ADJUSTMENT
3. Position the tool head manually against the edge of the rim so that both sides of the
Horizontal Adjustment of the Tool Head
1. Lower the automatic lever of the tool head to access the adjustment screws on the
56
head retaining bolt until some grip is obtained.
SCREW
tool head are resting on it. Keep the tool head in position without engaging the head
position lock.
side.
Operation Instructions for TCX56/57 Tire Charger
ADJUSTMENT
SCREW
HEAD
RETAINING
BOLT