Maintenance, Calibration And Replacement Parts; Maintenance Schedule - Hunter TCX575 Operation Instructions Manual

4. Maintenance, Calibration and

4.1 Maintenance Schedule

Maintenance Schedule
Periodically
Operation Instructions for TCX575 Tire Changer
Replacement Parts
Do not hose down or power wash electric tire changers.
CAUTION:
Proper care and maintenance are necessary to ensure that the TCX575 operates
properly. Proper care will also ensure that rims and tires are not damaged during the
mount/demount process.
Daily
Weekly
Perform the Following
Maintenance
Drain condensation from pressure regulator
reservoir by pressing in on the fitting located on
the bottom of the regulator.
Check for worn or damaged rubber and nylon
components that should be replaced to prevent
damage from occurring. Replace worn parts as
needed (tool supports, rubber pads, lever protector
sleeve and mount/demount head).
Clean all areas that contact rims or tires to prevent
possible scratching to rim.
Clean tire changer with shop towels or a vacuum
cleaner. Do not clean with or use compressed
air, which can blast dirt between moving parts.
Do not use cleaning solvents to clean pressure
regulator/oiler.
Refill the pressure regulator/oiler using only
Hunter Lubri-Oil, 148-133-2, as needed.
Petroleum-based oils should never be used in
the oiler and may void all warranties.
Adjust the oiler to release one drop of oil every
three rotations of the clamping table by adjusting
the screw on top.
Check for loose bolts and tighten per
specifications.
4. Maintenance, Calibration and Replacement Parts  31