Tcx57 - Leverless Mounting Head; Top Bead Demounting - Hunter TCX56 Operating Instructions Manual

TCX57 - LEVERLESS MOUNTING HEAD

Using leverless mounting head follow always this indications
CHECK MOUNT HEAD
CALIBRATION MONTHLY

Top Bead Demounting

Position the mount/demount head against the outer edge of the upper rim lip. The plastic
surfaces should contact the rim lip.
Slide the mount/demount head in or out along the upper rail and lower the head into position.
Lock the lever. Adjust the diameter knob for correct side spacing. The mount / demount head
will automatically build in the proper vertical spacing.
Always make sure the wheel is being rotated while inserting the automatic lever.
Locate an area with a gap between the tire and wheel.
Press the wheel rotation pedal
the automatic lever into the rim / tire assembly using the control switch.
Always ensure that the automatic lever is inserted in a gap between the rim and the
tire. If the automatic lever is inserted without a gap, tire damage can occur.
Operation Instructions for TCX56/57 Tire Charger
2 mm
1,5 mm
ALWAYS
LUBRICATE
TIRE
NOTICE
LUBE
ALWAYS MOUNT WITH BEAD
OVER BACK OF MOUNT HEAD
NOTICE
to rotate the wheel clockwise. While rotating, insert
NOTICE
USE ASSIST FEATURES
TO PREVENT DAMAGE
31