Table of Contents
Advertisement
1.8. Touch Screen Display Compo-
nents
1.9. Turning Power ON/OFF
Tire Changer is equipped with a push button power switch
located on the right side of the console, above the emer-
gency stop switch. Use this switch for normal shut down
and restarting procedures. The emergency stop switch lo-
cated right below the power switch. Push this stop for an
immediate termination of all hydraulic functions, e.g., spin-
dle rotation, tool movement, etc. Pull the switch back out
to resume hydraulic functions.
1.10. Touch Screen Display
A procedure wheel is located on the left side of the
screen. Steps can be skipped and accessed by rolling the
wheel up or down and touching the desired selection. In
most cases, touching a selection initiates a "slide-out"
menu providing additional functions.
Hunter Revolution™ Series Tire Changer
1.11. Wheel Lift / GO Pedal
To raise the wheel lift, press and hold down the right side
of the pedal. To lower the wheel lift, press and hold down
left side of the pedal. Once the spindle is vertical, the right
side of the pedal becomes the GO pedal. If the wheel lift is
less than vertical, the "GO" function is disabled until the
spindle is vertical.
1.12. Rotation Pedal
To rotate the spindle clockwise, press and hold down the
rotation pedal. Release when assembly is rotated to de-
sired position. To rotate the spindle counter clockwise, lift
and hold the rotation pedal. Release when assembly is ro-
tated to desired position.
NOTE
During normal operation, the GO ped-
al is pressed the majority of the time
to complete procedures. Releasing
the GO pedal will pause the current
procedure. Slide-out menus on the
touch screen procedure wheel may
change, allowing for other options. In
most cases, pressing back down on
the GO pedal will continue the previ-
ously paused procedure.
Page 6 of 12
Hide quick links:
Advertisement
Table of Contents
