Removal Of Wheel From Tc - Hunter TC33 Series Operation Instructions Manual

2.8 Removal of Wheel from TC

TC33 Series Tire Changer Operation Instructions
Incorrect
Step down completely on the air inflation pedal to release a high-pressure air blast
through the bead blast hose to assist in seating the beads of the tire.
Step down partially on the air inflation pedal to inflate tire and seat the beads.
WARNING: Do not exceed 40 PSI when seating the beads of a tire.
After beads have been seated, disconnect inflation hose and reinstall valve stem core
previously removed. Then connect inflation hose and inflate tire to the required
pressure.
If tire is over inflated, air may be removed from the tire by pressing the brass manual
air release button located below the air pressure gauge.
Disconnect inflator hose from valve stem.
NOTE: If repeated attempts with the blast inflation system fail, try
flipping the rim over and re-clamp. Try using the blast inflator
again.
Loosen clamping cone.
Press down quick clamp and turn counter-clockwise to unlock clamp from center
support. Remove wheel clamp.
Remove wheel from center support.
If applicable, remove anti-rotation pin extensions and wheel protector pad from center
support.
Correct
Basic Procedures• • • • 27