Removal Of Wheel From Tc - Hunter TC37 Series Operation Instructions Manual

HORIZONTAL

2.9 Removal of Wheel from TC

TC37 Series Changer Operation Instructions
Incorrect
Step down completely on the air inflation pedal to release a high-pressure air blast
through the bead blast hose to assist in seating the beads of the tire.
Step down partially on the air inflation pedal to inflate tire and seat the beads.
WARNING: Do not exceed 40 PSI when seating the beads of a tire.
After beads have been seated, disconnect inflation hose and reinstall valve stem core
previously removed. Then connect inflation hose and inflate tire to the required
pressure.
If tire is over inflated, air may be removed from the tire by pressing the manual air
release button located on the inflating hose.
Disconnect inflator hose from valve stem.
Loosen clamping cone.
Press down quick clamp and turn counter-clockwise to unlock clamp from center
support. Remove wheel clamp.
Remove wheel from center support.
If applicable, remove anti-rotation pin extensions and wheel protector pad from center
support.
HORIZONTAL
Correct
Basic Procedures• • • • 25