Install The Access Point On A Junction Box Or Gang Box; Install The Access Point On A Beam - Extreme Networks ExtremeWireless AP310i Installation Manual

Install the Access Point on a Junction Box or Gang Box

5. Squeeze the bracket parts together until you hear the T-bar locking tab click into place.
6. Slide the bracket base into the rear groove of the access point.
7. Hold and rock the access point back and forth to ensure that it is securely mounted.
8. Attach the RJ45 connector to the GE1 port.
9. Replace the ceiling tile.
Install the Access Point on a Junction Box or Gang Box
About This Task
The main mounting bracket or the optional WALL04 (#30516) bracket is used for installing the access
point on a junction box or gang box. The main mounting bracket is used only when the mounting holes
on the bracket and the box align.
Note
The box models are limited to the USA box models when using the main mounting bracket for
installation.
Procedure
1. Remove the screws holding the box coverplate.
2. Remove the LAN cable from the coverplate.
3. Place the WALL04 bracket, with the locking tab pointing up, against the mounting holes on the box.
If the WALL04 bracket holes do not align with the mounting holes on the junction or gang box, cut
and enlarge the holes on the WALL04 bracket.
4. Attach the WALL04 bracket to the junction or gang box using the screws removed from the junction
or gang box.
5. Connect the GE1 cable to the access point.
6. Slide the access point on the keyhole slots of the WALL04 bracket until you hear it lock in place.

Install the Access Point on a Beam

Before You Begin
Verify that the:
•
Beam attachment area is at least 0.5 in. (12.7 mm) wide and as long as the largest dimension of the
access point.
•
Beam mounting surface is less than 0.650 in. (16.5 mm) thick.
28 ExtremeWireless™ AP310i/e Access Points
Note
The bracket must be square to the rest of the room walls, and the two holes that are being
used must be on the opposite sides of large center hole on the WALL04 bracket.
Caution
Over tightening the screws will cause the WALL04 bracket to bend. If the bracket bends,
you will not be able to align and slide the access point onto the keyhole posts.
Install the Access Point