Installation
May 2019
Figure 3-15. 4–20 mA and Pulse Wiring with Electronic Totalizer/ Counter
+
-
A. Test ammeter
B. Pulse counter
3.6.7
Remote electronics
If you order one of the remote electronics options (options R10, R20, R30, R33, R50, or
RXX), the flowmeter assembly will be shipped in two parts:
1.
2.
Mounting
Mount the meter body in the process flow line as described earlier in this section. Mount
the bracket and electronics housing in the desired location. The housing can be
repositioned on the bracket to facilitate field wiring and conduit routing.
Cable connections
Refer to
cable to the electronics housing. (See
necting/disconnecting the meter adapter to the meter body.)
38
R
250
L
The meter body with an adapter installed in the bracket and an interconnecting
coaxial cable attached to it.
The electronics housing installed on a mounting bracket.
Figure 3-16
and the following instructions to connect the loose end of the coaxial
"Remote electronics procedure" on page 81
Rosemount 8600 Vortex Flow Meter
Reference Manual
00809-0100-4860, Rev BF
B
–
+
A
if con-