Powering Off - Huawei N2000H V3 User Manual

N2000H V3 Appliance
User Guide
For details about how to obtain the IP address for the management network port and how to
operate the iBMC, see the
Procedure
The power supply units (PSUs) are properly installed but not powered on.
The Appliance is powered on along with the PSUs.
The PSUs are powered on, and the Appliance is in the standby state.


----End
Verification
Check the indicator status after the Appliance is powered on.

3.2 Powering Off

This topic describes how to power off the Appliance.
Scenarios


Impact on the System
The services and programs running on the Appliance will be interrupted when it is powered
off.
Prerequisites
Conditions
The services running on the Appliance are forcibly stopped when the Appliance is powered
off. Check that all services are manually stopped or switched over to other Appliances before
powering off the Appliance.
Data


Issue 04 (2018-11-06)
HUAWEI Rack Appliance
Press the power button on the front panel to power on the Appliance.
The iBMC WebUI is available.
After logging in to the iBMC WebUI, on the menu bar, choose Power, in the navigation
tree, choose Power Control, and choose Power On > OK to power on the Appliance.
Power on the iBMC by running commands for remote management.
On the iBMC CLI, run the ipmcset -d powerstate -v 1 command to power on the
Appliance remotely.
The Appliance is to be powered off for maintenance.
The Appliance is to be powered off for movement.
All data is saved before the power-off operation.
You have determined the rack number and installation position for the device to be
powered off.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Powering On and Off the N2000H V3
iBMC User Guide.
64