Accessing The Cli Of The Ibmc Management Software - Huawei N2000H V3 User Manual

N2000H V3 Appliance
User Guide

Procedure
Step 1 Set an IP address for the PC, and ensure that the IP address is on the same network segment as
the iBMC management network port.
Step 2 Connect the PC to the iBMC management network port by using a network cable.
Step 3 Run Internet Explorer on the PC, enter the IP address of the iBMC management network port
in the address box, and press Enter. Then enter a user name and password to log in, as shown
in Figure
Figure 9-4 iBMC home page
----End

9.3 Accessing the CLI of the iBMC Management Software

This topic describes how to access the CLI of the management software.
Scenarios
You can log into the iBMC CLI to manage and monitor the device.
There are ways to access the CLI of the management software, choose the way based on
actual site requirements.
Prerequisites
Conditions
To open the CLI through the network interface, you must connect the network interface of the
configuration terminal to the network interface of the Appliance by using a network cable, and
ensure that the IP addresses of the two network interfaces are on the same network segment.
Data

Issue 04 (2018-11-06)
You have obtained the user name and password for logging in to the iBMC.
7-4.
The IP address of the iBMC management network port.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Common Operations
251