Connecting A Power Cable - Huawei N2000H V3 User Manual

N2000H V3 Appliance
User Guide
Documents
Hardware
The serial cable uses a DB9 connector.
Procedure
Step 1
Do not exert excessive force; otherwise, the pins in the serial port may be damaged.
Align the connector on the serial cable with the serial port, and insert the connector into the
serial port, as shown in
Step 2 Tighten the screws on the connector to secure the serial cable.
Figure 2-24 Connecting a serial cable
----End

2.4.6 Connecting a Power Cable

Scenarios
Connect a power cable for the Appliance in the following scenarios:


Issue 04 (2018-11-06)
For details about the command for setting the serial port to the iBMC serial port, see the
Appliance iBMC User Guide.
Figure
The Appliance is to be powered on after being properly installed.
A power supply unit (PSU) is replaced and the new PSU is to be powered on.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Installing and Removing the N2000H V3
2-24.
HUAWEI Rack
56