Checking The N2000H V3 - Huawei N2000H V3 User Manual

N2000H V3 Appliance
User Guide
Table 4-2
Table 4-2 Procedures for configuring the Appliance
Procedure
Checking the Appliance
Configuring RAID properties
Configuring the basic
input/output system (BIOS)
Changing the user password
for iBMC
Installing an operating system
(OS)

4.2 Checking the N2000H V3

This topic describes how to check the N2000H V3 initial status.
Scenarios
Log in to the iBMC WebUI or CLI to check the health status of the N2000H V3. Ensure that
its health status meets the environment requirements for software installation.
Prerequisites
Conditions
The N2000H V3 is powered on.
Data


Table 4-3 Default information
Item
iBMC management
network port
Issue 04 (2018-11-06)
describes the procedures for configuring the Appliance.
You have obtained the user names and passwords for logging in to the N2000H V3
iBMC WebUI or CLI.
You have obtained the IP address for the N2000H V3 iBMC management network port.
Parameter
IP address and subnet
mask of the
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description

Check that the board versions are the required ones.
 Check for alarms about the Appliance.
The N2000H V3 supports the LSISAS2308,
LSISAS3008, and LSISAS3108 controller cards.
Configure RAID properties for the Appliance based on
actual site requirements.
Configure the Appliance BIOS, including the boot mode,
network drive, preboot execution environment (PXE)
options of the network interface card (NIC), and BIOS
password.
Change the default password for the iBMC.
For details, see HUAWEI Appliance OS Installation
Guide.
Default Value

Default IP address: 192.168.2.100
 Default subnet mask: 255.255.255.0
4 Configuring the N2000H V3
68