Section 2 – Operator Safety
2.3 Cab Access
WARNING
Entering and exiting the telehandler should only be
done using the three points of contact.
Use three points of contact to enter and exit the cab.
Face the telehandler when entering or exiting the cab.
Three points of contact means that two hands and
one foot or one hand and two feet are in contact
with the telehandler or the ground at all times during
entering and exiting.
WARNING
Operator should not use any telehandler that:
does not appear to be working properly.
▪
has been damaged or appears to have worn
▪
or missing parts.
has alterations or modifications not approved
▪
by the manufacturer.
has safety devices which have been altered or
▪
disabled.
has been tagged or locked out for non-use or
▪
repair.
bears an unapproved attachment.
▪
Failure to avoid these hazards could result in death
or serious injury.
216201ADA
20
2.4 Jobsite Inspection
Be sure to follow all local, provincial/territorial/
state and national regulations related to operating
variable reach rough terrain forklifts. Do not use the
telehandler in hazardous locations.
Perform a thorough jobsite inspection prior to
operating the telehandler to identify potential hazards
in your work area.
It is the responsibility of the operator to perform a job
site inspection and avoid the following hazardous
situations:
holes or drop-offs
▪
ditches or soft fills
▪
floor obstructions, bumps or debris
▪
overhead obstructions
▪
electrical cords, hoses and high voltage
▪
conductors
hazardous locations
▪
inadequate surface support to withstand all load
▪
forces imposed by the telehandler
wind and weather conditions
▪
the presence of unauthorized personnel
▪
other possible unsafe conditions
▪
Cab Access
SJ643 TH & SJ843 TH