Operator's Cab Dash Controls - Skyjack SJ643 TH Operating Manual

Section 3 – Familiarization
1
2
3
4

3.3-4 Operator's Cab Dash Controls

Fuel Gauge: Indicates the amount of fuel in the
1
fuel tank. Fill the tank with ultra low sulfur diesel
fuel only when the indicator needle moves below
the 1/4 tank mark.
Transmission Range Selector (If equipped):
2
Located on the direction control lever. The
transmission has three speeds in either direction.
Rotate handle grip to select speed range.
Left and Right Turn Signals Switch (If
3
Equipped): This rocker switch controls left and
right turn signals located on both the front and
rear of the telehandler.
Engine Data Display Module: Allows the
4
operator to select the required engine data such
as engine RPM, engine temperature, voltage,
and visualize it in the following formats:
Analogue display
▪
Digital data
▪
Graphics
▪
Multi-data (a combination of the above)
▪
Current alarm messages
▪
(Refer to Section 5.11
Hazard Warning Light Switch (If Equipped):
5
The hazard warning light switch activates all four
turn signals to indicate an emergency situation.
216201ADA
26
26 25
FWD
N
REV
5
5 6 7
for details).
24 23 22 21
P
8 9 10 11 12 13
Transmission Oil Temperature Indicator:
6
This red light indicator illuminates when the
transmission oil temperature is not within the
normal operating range.
Rear Axle Lock Indicator: This red light
7
indicates frame leveling is in slow/controlled
mode, or locked mode when park and/or service
brakes are applied.
Glow Plug Indicator: This light illuminates until
8
glow plugs have completed their timed cycle.
When the lamp goes out, the engine is ready to
be started.
Control Functions
20 19 18
17
16
14 15
SJ643 TH & SJ843 TH