Machine Operation; Start Up; Shutdown; Emergency Stop Button - Baileigh Industrial BP-3305CNC Operator's Manual

MACHINE OPERATION

CAUTION:
footwear, and leather gloves to protect from burrs and sharp edges.
When handling large heavy materials make sure they are properly supported.
Keep hands and fingers clear of the bending dies. Stand off to the side of the
machine to avoid getting hit with the work material while the punch is pressing the
material into the bending die.

Start Up

1. Turn the main disconnect to the ON position. The
white power light (A) will be lit.
2. Turn the power key switch (B) to ON when ready to
start.
3. Allow the controller display to complete the boot
process.
4. Press the pump start button (C). The green power
light will be lit.
5. Start completed.

Shutdown

1. Turn Selector Switch (E) to the INCH (left) position
and press the down foot pedal to lower the ram to
the bottom of the stroke or until it just makes
contact with the lower die.
2. Turn the power key switch (B) to OFF and remove
the key.
3. Turn the main disconnect to OFF to shutdown the
controller.

Emergency Stop Button

1. In the event of incorrect operation or dangerous conditions, the machine can be stopped
immediately by pressing the E-STOP button.
2. Twist the emergency stop button clockwise (cw) to reset.
Note: Resetting the E-Stop will not start the machine.
Always wear proper eye protection with side shields, safety
25
A
E
25
D
B C
F