Power Cord Connection - Baileigh Industrial BP-3305CNC Operator's Manual

WARNING:
properly grounded. If you are not sure, have a qualified electrician check the
receptacle
.
• Improper connection of the equipment-grounding conductor can result in risk of electric
shock. The conductor with insulation having an outer surface that is green with or without
yellow stripes is the equipment-grounding conductor. If repair or replacement of the electric
cord or plug is necessary, do not connect the equipment-grounding conductor to a live
terminal.
• Check with a qualified electrician or service personnel if the grounding instructions are not
completely understood, or if in doubt as to whether the machine is properly grounded.
• Repair or replace damaged or worn cord immediately.

Power cord connection:

1. Unlock and open the electrical enclosure door.
2. Insert a fitting into the open hole at the bottom left of the electrical cabinet to grip the power
cord (supplied by customer).
3. Route a power cord (customer supplied) from the power supply to the electrical cabinet at
the bottom left of the cabinet.
a. Route the power cord so that it will NOT become entangled in the machine in any
way.
b. Route the cord to the power supply in a way that does NOT create a trip hazard.
4. Connect the three power wires to the terminals L1, L2, & L3. Connect the ground wire
(typically green) to the E terminal.
5. Check that the power cord has not been damaged during installation.
Check for correct rotation of the motor
6. Close the electrical enclosure door.
7. With power connected and the main disconnect turned ON, the power light on the control
panel will be lit.
8. Start and stop the pump motor watching the fan end of the motor to verify the direction of
rotation matches that directional arrow on the fan cover.
9. If motor rotation is not correct, disconnect power to the machine, and switch the L1 and L3
wires. DO NOT move the ground wire.
In all cases, make certain the receptacle in question is
17
17