Anchoring The Machine - Baileigh Industrial BP-3305CNC Operator's Manual

• FLOOR: This machine distributes a large amount of weight over a small area. Make certain
that the floor is capable of supporting the weight of the machine, work stock, and the
operator. The floor should also be a level surface. If the unit wobbles or rocks once in place,
be sure to eliminate by using shims.
• WORKING CLEARANCES: Take into consideration the size of the material to be
processed. Make sure that you allow enough space for you to operate the machine freely.
• POWER SUPPLY PLACEMENT: The power supply should be located close enough to the
machine so that the power cord is not in an area where it would cause a tripping hazard. Be
sure to observe all electrical codes if installing new circuits and/or outlets.

Anchoring the Machine

• Once positioned, anchor the machine to the floor. Use bolts and expansion plugs or sunken
tie rods that connect through and are sized for the holes in the base of the stand.
• This machine requires a solid floor such as concrete at a minimum of 5.9" (150mm) thick.
7.8" (200mm) minimum is preferred.
13
13