Sony PCS-1 Operating Instructions Manual page 164

Message
Connection with the Data Solution Box is
not correct. Please reset the system.
Fan in the Data Solution Box does not work
properly. The Data Solution Box is not
usable.
Whiteboard cannot be used.
Battery in the stylus could be weak. Replace
the battery.
The following messages indicate the state of the system. No action is required.
Message
Meeting starts!
Starting connection.
Meeting ends.
Please wait.
Installation completed.
Transmission of the still picture is
completed.
Still image transmission
cancelled.
Load a camera angle saved to
Preset number 1 (–6).
Still image saved.
Registered to Preset number 1 (–
6).
Terminal A (or B, C, D, E) has
disconnected.
Site A (or B, C, D, E) has
disconnected.
The still image from the object
input has been transmitted.
The slide show is over.
The 1st (–5th) position has been
selected.
The terminal participated in the
conference.
164
On Screen Messages
Meaning
Connection between the Communication Terminal
and the Data Solution Box is not correct. Turn off
the Communication Terminal, then turn it on again.
The fan equipped with the Data Solution Box is
not working properly. You cannot use the Data
Solution Box.
The whiteboard can be used for a videoconference
only between PCS-1/1P systems.
The battery in the stylus for the whiteboard is low.
Replace the battery in the stylus with a new one.
Meaning
Connection with the remote party has been completed, and
you can now start a conference.
After receiving a call from the remote party the system starts
connecting.
Operations for ending the conference have been completed.
The data is being saved.
Installing the software is completed.
A still picture has been transmitted to the remote party.
Transmission of a still image has been cancelled.
The camera angle and zoom setting has been changed to that
registered in Preset number 1 (–6).
The still image has been saved to the "Memory Stick".
The camera angle and zoom setting has been registered in
Preset number 1 (–6).
During a multipoint videoconference the remote party A (or
B, C, D, E) has been disconnected.
During a multipoint videoconference the remote party A (or
B, C, D, E) has ended the conference.
The still image input from the Document Stand has been
transmitted.
The slide show has been ended.
The terminal on the 1st (–5th) site for a multipoint
videoconference has been selected from the Phone Book.
The remote party of the displayed terminal participates in the
multipoint videoconference.