The system begins dialing the number of the remote party with the
Dialing (LAN)" or "
and the ON LINE indicator (blue) on the Communication Terminal blinks.
When the system connects to all the parties, the message "Meeting starts!"
appears on the screen, and the ON LINE indicator stops blinking and lights.
To call remote parties not registered in the Phone Book
Basic operations are the same as those for starting a point-to-point conference.
For details, see "To call a remote party not registered in the Phone Book" on
Select "Dial" in the launcher menu to open the Dial menu.
Select the line interface you are using for multipoint connection under
Set up the line interface of the remote parties.
Select the LAN bandwidth to be used and enter the IP addresses of all the
Enter the telephone numbers of all the parties.
To register a normal phone, enter the telephone number with "T" at the
beginning. (e.g., T0312345678)
For details on the setups, see step 3 in "To call a remote party not
registered in the Phone Book" on page 61.
Select "Dial", and press the PUSH ENTER button on the Remote
Commander. You can also press the CONNECT/DISCONNECT (
button on the Remote Commander.
Dialing (ISDN)" appears on the monitor screen,
LAN" to use LAN connection, and "
LAN" is selected
ISDN" is selected
ISDN" to use ISDN line
Starting a Multipoint Videoconference