Download  Print this page

Advertisement

Message
180
Dialing your own number is
invalid.
181
GateKeeper error.
Busy line - Connection not possible.
Far end inactive
System not responding.
Close this menu to connect line
Cannot establish all connections
Connection time out.
Communication error
Configuration error
Command is rejected by MCU.
Corruptive data stream. Terminating the
connection
Memory full
Input title
Operation disabled
Wrong password
01H LAN configuration error
(IP address)
02H LAN configuration error
(Netmask)
03H LAN configuration error
(MAC address)
04H LAN configuration error
(DHCP error)
05H Gatekeeper registration error
06H SNMP error
LAN configuration error
(Gatekeeper)
LAN configuration error
(SNMP error)
LAN configuration error
Memory Stick error.
General error.
162
On Screen Messages
Meaning
Please check the IP address of the remote party.
Please check the IP address of the remote party.
The telephone line of the remote party is busy and
cannot be connected.
The remote party operates the menu, and the still
picture cannot be sent.
Check if the remote system is connected.
Close the menu when starting a conference.
Check the telephone number of the remote party.
Wait for a while and then try dialing again.
Wait for a while and then try dialing again.
Wait for a while and then try dialing again.
The function is not available when external MCU is
connected.
A signal error occurred. The line connections are
compelled to be disconnected.
The memory capacity of the "Memory Stick" is
full.
Input an index title.
The password is not correct.
Enter the correct password.
The IP address is not proper.
The netmask is not proper.
The MAC address is not proper.
The IP address and netmask cannot be obtained.
The setting of the Gatekeeper is not proper.
SNMP is not set properly.
The setting of the Gatekeeper is not proper.
The setting of the SNMP is not proper.
The settings in the LAN Setup menu are not proper.
The format of the "Memory Stick" is wrong.

Advertisement

Table of Contents

This manual is also suitable for:

Pcs-1p

Comments to this Manuals

Symbols: 0
Latest comments: