To display the local picture in the Voice Activate mode
You can display the local picture only on your monitor screen while the
broadcast mode remains in Voice Activate mode.
Press the FAR/NEAR button on the Remote Commander.
The Display Control menu appears.
Use the V, v, B or b button to select "Near" under "Display", then press
the PUSH ENTER button.
The local picture appears on your monitor screen.
To restore the Voice Activate mode
Press the FAR/NEAR button on the Remote Commander again, and select
"Far" under "Display".
Receiving the Broadcast Requested From Any Other Terminal
When you receive "Self Broadcast" command from one of the terminals
connected, the picture of that terminal is broadcast in full screen.
When you receive "Stop Broadcat" command from one of the terminals
connected, the system returns to the previous mode.
• If you have received "Self Broadcast" command from another terminal or you have
selected the picture to be broadcast, the "Self Broadcast" command is rejected and the
operation above will not be carried out.
• When you use a cascade connection, the Video Communication System supports the
Voice Activate mode only. Therefore, the operation above will not be carried out.
Using the Display Control