Receiver Rear Panel - Extron electronics FOX T Plus MM User Manual

Rx (link) LED — Lights steadily when a signal is passing between the transmitter Rx
D
port and the receiver Tx port.
Tx (link) LED — Lights steadily when a signal is passing between the transmitter Tx
E
port and the receiver Rx port. The green Rx and Tx LEDs light and remain lit while a
valid connection exists between the LC SFP connector of the transmitter and receiver
and both units have power.

Receiver Rear Panel

The receiver rear panel has the following features:
POWER
12V
1.0A MAX
A A A
Power connector
A
LC SFP connector
B
USB hub connectors (Outputs)
C
Figure 5.
Power connector — Connect a provided 12 VDC power supply into this 2-pole,
A
3.5 mm captive screw connector.
ATTENTION:
•
•
LC SFP connector — Connect the free ends of the fiber optic cable pair attached to
B
the LC SFP connector of the transmitter (see
connector (see
USB hub connectors — The built-in four-port hub has four female USB Type A
C
connectors. The connections are USB 3.0 compatible, providing +5 VDC at up to
500 mA to connected USB peripherals requiring power.
Rx (link) LED — Lights steadily when a signal is passing between the transmitter Rx
D
port and the receiver Tx port.
Tx (link) LED — Lights steadily when a signal is passing between the transmitter Tx
E
port and the receiver Rx port.
These green LEDs light and remain lit while a valid connection exists between the
LC SFP connectors of the transmitter and receiver and both units have power.
E E E E E D D D D D
Tx
OPTICAL
B B B
Receiver (Rx) Rear Panel Connectors
Do not connect any external power supplies until you have read the
Attention notifications on page 8.
Ne branchez pas de sources d'alimentation externes avant d'avoir lu les
mises en garde de la page 8.
Connecting the Fiber Cable
FOX T/R USB Extender Plus • Installation and Operation
Rx
1 3
2 4
C C C
Rx (link) LED
D
Tx (link) LED
E
figure 4, , on page 7) to this LC SFP
C
on page 13).
9