Pairing With Underfloor Heating Wiring Centre (Kl08Rf/Control Box) - Salus QUANTUM SQ610RF Full User Manual

7.2 Pairing with underfloor heating wiring centre (KL08RF/Control Box)

PLEASE NOTE!
For easier installation, please make sure you have already added underfloor heating wiring centre (KL08RF/Control Box) to your ZigBee network (please
refer to the underfloor heating wiring centre manual instruction).
1
Select your language using
buttons and confirm by
4
Select system type: UNDERFLOOR,
press button to confirm.
7
You can pair your thermostat with
more than one zone. Select additional
zones or finish the pairing process by
button.
REPLACE ZONE:
If user during pairing process will choose already occupied zone then thermostat will display „ZONE OCCUPIED" message. Occupied zone can be replaced
by other thermostat. It will remove current thermostat assigned to that zone. Please look at the steps below:
50
2
or
Now thermostat is looking for the
button.
signal from the coordinator...
5
Using
Control Box number. Press
confirm.
8
1
and buttons select the
button to
When thermostat is succesfully
paired main screen will be
displayed.
2
3
5 sec.
OR
5 sec.
Open the ZigBee network
6
Use or buttons to select
the zone number and press
button to confirm.
5 sec.
9
OR
5 sec.
Close the ZigBee network
3
3