Pairing The St620Rf Receiver And Control Centre - Salus ST620RF Instruction Manual

ST620RF Manual Version 005 CMYK:Layout 1 1/9/10 11:56 Page 8

PAIRING THE ST620RF RECEIVER AND CONTROL CENTRE

It is important to correctly pair both the Receiver and Control Centre to ensure that the RF address codes are matched
and that reliable communication is established between the units. Please follow the instructions below to ensure that the
units are configured correctly.
On the Receiver:
Press and hold the SYNC button to allow the Receiver to enter the learning mode. The Red SYNC LED will turn on to
indicate it is ready to receive a signal and pair with another unit.
While the signal is being received, the SYNC LED will turn on until the pairing has completed successfully; the SYNC LED
will then turn off and the Green Power LED will turn on again. The Control Centre will continue to transmit a pairing signal
for 10 minutes before returning to NORMAL mode.
On the Control Centre:
The Arrow key is not active when the ST620RF is in NORMAL mode. To access the Menu screens,
press the OK key twice. The first menu displayed is the PROGRAMME menu:
8 ST620RF INSTRUCTION MANUAL