7.4 Pairing with RX10RF receiver
PLEASE NOTE!
For easier installation, please make sure you have already added RX10RF receiver to your ZigBee network (please refer to the RX10RF receiver manual
instruction).
1
Select your language by
buttons and confirm by
4
Press
button for 3 seconds to expand
"SYSTEM TYPE" menu.
7
5 sec.
5 sec.
Close the ZigBee network
52
2
or
button.
5
Use
- choose pairing with the RX10RF receiver in
the „RX1" configuration, if the receiver is set as
RX1 (receiver responds to the heating signal
from any thermostat),
- choose pairing with the RX10RF receiver in
the „RX2" configuration, if the receiver is set as
RX2 (receiver responds to the heating signal
from only one thermostat).
Confirm by
3
OR
3
Now thermostat is looking for the
signal from the coordinator...
or
buttons to:
button
3
5 sec.
OR
5 sec.
Open the ZigBee network
6
After all you will see the main
thermostat's display.