gefran SIEIDrive ADV50 Series Quick Start-Up page 59

Pr. Explanation
Over-Current Stall
06.02 Prevention during
Operation
Over-Torque
06.03 Detection Mode
(OL2)
Over-Torque
06.04
Detection Level
Over-Torque
06.05
Detection Time
Electronic Thermal
06.06 Overload Relay
Selection
Electronic Thermal
06.07
Characteristic
06.08 Present Fault Record
Second Most Recent
06.09
Fault Record
Third Most Recent
06.10
Fault Record
Fourth Most Recent
06.11
Fault Record
06.12 Fifth Most Recent
Fault Record
Italiano
0:Disable
20 to 250%
0: Disabled
1: Enabled during constant speed operation.
After the over-torque is detected, keep running
until OL1 or OL occurs.
2: Enabled during constant speed operation.
After the over-torque is detected, stop running.
3: Enabled during accel. After the over-torque is
detected, keep running until OL1 or OL occurs.
4: Enabled during accel. After the over-torque is
detected, stop running.
10 to 200%
0.1 to 60.0 sec
0: Standard motor (self cooled by fan)
1: Special motor (forced external cooling)
2: Disabled
30 to 600 sec
0: No fault
1: Over current (oc)
2: Over voltage (ov)
3: IGBT Overheat (oH1)
4: Power Board Overheat (oH2)
5: Overload (oL)
6: Overload1 (oL1)
7: Motor over load (oL2)
8: External fault (EF)
9: Current exceeds 2 times rated current during
accel.(ocA)
10: Current exceeds 2 times rated current during
decel.(ocd)
11: Current exceeds 2 times rated current during
steady state operation (ocn)
12: Ground fault (GFF)
13: Reserved
14: Phase-Loss (PHL)
15: Reserved
16: Auto Acel/Decel failure (CFA)
17: SW/Password protection (codE)
18: Power Board CPU WRITE failure (cF1.0)
19: Power Board CPU READ failure (cF2.0)
20: CC, OC Hardware protection failure (HPF1)
21: OV Hardware protection failure (HPF2)
22: GFF Hardware protection failure (HPF3)
23: OC Hardware protection failure (HPF4)
24: U-phase error (cF3.0)
25: V-phase error (cF3.1)
26: W-phase error (cF3.2)
27: DCBUS error (cF3.3)
28: IGBT Overheat (cF3.4)
29: Power Board Overheat (cF3.5)
English
Settings
ADV50 QS, SW-PW V1.11 / CTL V2.11
Factory
NOTE
Setting
170
0
150
0.1
2
60
0
19