gefran SIEIDrive ADV50 Series Quick Start-Up page 54

Pr. Explanation
02.07 Up/Down Mode
Accel/Decel Rate of
Change of UP/DOWN
02.08
Operation with
Constant Speed
Source of Second
02.09
Frequency Command
Combination of the
First and Second
02.10
Master Frequency
Command
Keypad Frequency
02.11
Command
Communication
02.12
Frequency Command
The Selections for
Saving Keypad or
02.13
Communication
Frequency Command
Initial Frequency
02.14 Selection (for keypad
& RS485/USB)
Initial Frequency
02.15 Setpoint (for keypad
& RS485/USB)
Display the Master
02.16 Freq Command
Source
Display the Operation
02.17
Command Source
Multi-function Output
03.00 Relay (RA1, RB1,
RC1)
14 ADV50 QS, SW-PW V1.11 / CTL V2.11
0: by UP/DOWN Key
1: Based on accel/decel time
2: Constant speed (Pr.02.08)
3: Pulse input unit (Pr.02.08)
0.01~10.00 Hz
0: Digital keypad UP/DOWN keys or Multi-
function Inputs UP/DOWN. Last used frequency
saved.
1: 0 to +10V from AVI
2: 4 to 20mA from ACI or 0 to +10V from AVI2
3: RS-485 (RJ-45)/USB communication
4: Digital keypad potentiometer
0: First Master Frequency Command
1: First Master Frequency Command+ Second
Master Frequency Command
2: First Master Frequency Command - Second
Master Frequency Command
0.00 to 600.0Hz
0.00 to 600.0Hz
0: Save Keypad & Communication Frequency
1: Save Keypad Frequency only
2: Save Communication Frequency only
0: by Current Freq Command
1: by Zero Freq Command
2: by Frequency Display at Stop
0.00 ~ 600.0Hz
Read Only
Bit0=1: by First Freq Source (Pr.02.00)
Bit1=1: by Second Freq Source (Pr.02.09)
Bit2=1: by Multi-input function
Bit3=1: by PLC Freq command
Read Only
Bit0=1: by Digital Keypad
Bit1=1: by RS485 communication
Bit2=1: by External Terminal 2/3 wire mode
Bit3=1: by Multi-input function
Bit4=1: by PLC Operation Command
Group 3 Output Function Parameters
0: No function
1: AC drive operational
2: Master frequency attained
3: Zero speed
4: Over torque detection
Settings
Italiano
Italiano
Factory
NOTE
Setting
0
0.01
0
0
60.00
60.00
0
0
60.00
##
##
8
English
English