Operator Maintenance; Lubrication Specifications - JLG E300AJ Operation And Safety Manual

7.4

OPERATOR MAINTENANCE

NOTE: The following numbers correspond to those in the previous dia-
gram.
Table 7-14. Lubrication Specifications.
KEY
MPG Multipurpose Grease having a minimum dripping point of 350 degrees F.
Excellent water resistance and adhesive qualities; and being of extreme
pressure type (Timken OK 40 pounds minimum).
EPGL Extreme Pressure Gear Lube (oil) meeting API Service Classification GL-5 or
Mil-Spec Mil-L-2105.
HO Hydraulic Oil. Mobil DTE-11M
BG* Bearing Grease (JLG Part No. 3020029) Mobilith SHA 460.
*MPG may be substituted for these lubricants, if necessary, but service intervals will be
reduced.
LUBRICATION INTERVALS ARE BASED ON MACHINE OPERATION UNDER NORMAL
CONDITIONS. FOR MACHINES USED IN MULTI-SHIFT OPERATIONS AND/OR EXPOSED
TO HOSTILE ENVIRONMENTS OR CONDITIONS, LUBRICATION FREQUENCIES MUST BE
INCREASED ACCORDINGLY.
31215000
SECTION 7 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
SPECIFICATIONS
1. Swing Bearing
Lube Point(s) - Remote Fitting
Capacity - A/R
Lube - BG
Interval - Every 3 months or 150 hrs of operation
Comments - Apply grease and rotate in 90 degree
intervals until bearing is completely lubricated
7-9