JLG E300AJ Operation And Safety Manual page 45

SECTION 3 - MACHINE CONTROLS AND INDICATORS
TO AVOID SERIOUS INJURY, DO NOT OPERATE MACHINE IF ANY CONTROL LEVERS OR
TOGGLE SWITCHES CONTROLLING PLATFORM MOVEMENT DO NOT RETURN TO THE
OFF OR NEUTRAL POSITION WHEN RELEASED.
1. Speed Mode
Activating the Speed Mode switch allows
the operator to select High or Low Speed
travel operation.
ONLY USE THE PLATFORM LEVELING OVERRIDE FUNCTION FOR SLIGHT LEVELING OF
THE PLATFORM. INCORRECT USE COULD CAUSE THE LOAD/OCCUPANTS TO SHIFT OR
FALL. FAILURE TO DO SO COULD RESULT IN DEATH OR SERIOUS INJURY.
2.
Platform Leveling Override
A three position switch allows the operator to
adjust the automatic self leveling system. This
switch is used to adjust platform level in situa-
tions such as ascending/descending a grade.
3-10
3. Horn
A push-type HORN switch supplies electrical
power to an audible warning device when pressed.
4.
Power/Emergency Stop Switch
A two-position red mushroom shaped
switch furnishes power to PLATFORM Con-
trols when pulled out (on). When pushed
in (off ), power is shut off to the platform
functions.
5.
Drive Orientation Override
When the boom is swung over the rear tires
or further in either direction, the Drive Orien-
tation indicator will illuminate when the drive
function is selected. Push and release the
switch, and within 3 seconds move the Drive/Steer control
to activate drive or steer. Before driving, locate the black/
white orientation arrows on both the chassis and the plat-
form controls. Move the drive controller in a direction
matching the directional arrows for the intended direction
of travel.
31215000