JLG E300AJ Operation And Safety Manual page 46

NOTE: To operate the Drive joystick, pull up on the lock-
ing ring below the handle.
NOTE:
The Drive joystick is spring loaded and will auto-
matically return to neutral (off) position when
released.
6.
Drive/Steer
Push forward to drive forward,
pull back to drive in reverse.
Steering is accomplished via a
thumb-activated rocker switch on
the end of the drive joystick.
NOTE:
When lower boom is raised above horizontal, or the upper boom
is raised approximately 16 inches (40.64 cm) above boom rest,
the high drive function will automatically switch to low drive.
This also occurs when Function Speed Control is clicked on creep.
7. Telescope
Provides extension and retraction of the main
boom.
31215000
SECTION 3 - MACHINE CONTROLS AND INDICATORS
8. Jib
Provides for raising or lowering of the jib.
9. SkyGuard Override Switch
The switch enables functions cut out by
the Skyguard system to be operated
again, allowing the operator to resume
use of machine functions.
10. Jib Swing (If equipped)
Provides jib swing right or left.
11.
Lower Boom Lift
Provides raising and lowering of the upright
and lower booms.
3-11