Tires & Wheels; Tire Replacement - JLG E300AJ Operation And Safety Manual

Hide thumbs Also See for E300AJ:
Table of Contents

Advertisement

SECTION 7 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
When adding water to the battery, fill only to level indicated or
3/8" above separators.
1.
Charge batteries at the end of each work day, or when
machine performance is significantly reduced due to batter-
ies becoming discharged.
2.
Charge batteries in accordance with the following proce-
dure:
a. Open battery compartment, and battery charger com-
partment covers.
WHEN BATTERY CHARGER IS TO BE USED, CHARGING HARNESS MUST BE PLUGGED
INTO A GROUNDED RECEPTACLE. IF RECEPTACLE IS NOT GROUNDED AND A MALFUNC-
TION SHOULD OCCUR, THE MACHINE COULD CAUSE SERIOUS ELECTRICAL SHOCK.
b. Remove charging harness cable and connect to a
receptacle or the correct voltage.
c. Allow batteries to charge until 100% LED is illuminated.
NOTE:
When batteries are completely charged, disconnect charging
harness cable from receptacle. Store charging harness cable.
d. Ensure battery cables are properly positioned and are
not pinched. Close and secure all compartment doors.
7-14
7.6
TIRES & WHEELS

Tire Replacement

JLG recommends a replacement tire be the same size, ply and brand
as originally installed on the machine. Please refer to the JLG Parts
Manual for the part number of the approved tires for a particular
machine model. If not using a JLG approved replacement tire, we
recommend that replacement tires have the following characteris-
tics:
• Equal or greater ply/load rating and size of original
• Tire tread contact width equal or greater than original
• Wheel diameter, width, and offset dimensions equal to the
original
• Approved for the application by the tire manufacturer
(including inflation pressure and maximum tire load)
Unless specifically approved by JLG Industries Inc. do not replace a
foam filled or ballast filled tire assembly with a pneumatic tire. When
selecting and installing a replacement tire, ensure that all tires are
inflated to the pressure recommended by JLG. Due to size variations
between tire brands, both tires on the same axle should be the same.
31215000

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

E300ajp

Table of Contents