Removing The Ignition Switch/ Steering Lock; Removing The Right And Left; Handlebars - APRILIA SL Mille Workshop Manual

SL mille
7.1.16 REMOVING THE IGNITION SWITCH/
STEERING LOCK
Carefully read 0.4.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
• Position the vehicle on the stand.
• Turn the ignition switch to position
"§".
• Remove the front part of the fairing, see 7.1.19 (RE-
MOVING THE FRONT PART OF THE FAIRING).
• Release the wiring from the fastening clamp (1).
NOTE
Prepare the same number of clamps, which will
be required for reassembly.
• Disconnect the electric connector (2).
When reassembling, make sure the connector is
plugged in properly.
Ignition switch/steering lock screw driving torque: 25
Nm (2.5 kgm).
• Unscrew and remove the screw (3) and take the bush-
ing.
NOTE
When reassembling, position the cable guide
(4) correctly.
• Use a chisel to cut into the head of the special screw (5)
and turn it until it loosens.
• Unscrew the screw (5) by hand and remove it.
NOTE
When reassembling, use another screw of the
same type, tightening it until the head comes off.
• Remove the ignition switch/steering lock (6), sliding it
out form underneath.
7.1.17 REMOVING THE RIGHT AND LEFT
HANDLEBARS.
Carefully read 0.4.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
• In order to remove the left handlebar, remove the con-
trols, see 7.1.9 (REMOVING THE GRIP ON THE LEFT
HANDLEBAR) .
• In order to remove the right handlebar, remove the con-
trols, see 7.1.13 (REMOVING THE THROTTLE GRIP).
• Perform the operations described in chapter 2.28.2
(ADJUSTING THE BEARING SLACK STEERING).
Handlebar screw driving torque: 25 Nm (2.5 kgm).
. • Loosen the screw (7).
• Slide the left/right handlebar (8) off the fork.
NOTE
Where necessary, repeat the last two opera-
tions to remove the other handlebar.
CHASSIS
Release 00/2001-05 - - - - - - - - - -
11-
1
5 - 00