APRILIA SL Mille Workshop Manual page 300

SL mille
8.1.3 BATTERY
Battery elements have lost much active material consequent on
excessive charge.
Presence of short circuits inside battery owing to excessive
accumulation of sediments
Old battery
REPAIR INFORMATION
Check the the
regulator/rectifier, the
circuit connections and
carry out operations
necessary to restore
correct recharge
Change the battery and
repair charging system
Change the battery
Change the battery
I3cttterypolarityJnvertecJ
8.1.4 BRAKES
Battery has beenincorrectly connected. to the system Changethebattery.and
make sure new one is
connected properly
Poor braking power
Brakes squeak
Excessive stroke of
brake lever
Brake fluid leakage
Brake fluid leakage from hydraulic system
Brake pads worn
Contact surfaces of pads soiled by oil, grease or brake fluid
Brake discs worn
Air in hydraulic circuit
Brake discs dirty with oil, grease or brake fluid
Foreign matter in brake fluid
Brake pump return hole clogged
Pad contact surfaces hardened
Pads installed backwards
Wheel bearing damaged
Front or rear wheel pin loose
Brake pads worn
Air in hydraulic circuit
Insufficient brake fluid
Unsuitable brake fluid
Brake caliper pins locked
Insufficient tightening of connection fittings
Cracked pipes
Pumping element and/or body worn
Repair or replace
Change pads
Change pads
Change disc
Bleed the circuit
Clean
Change brake fluid
Disassemble and clean
brake pump
Restore su rfaces with
sandpaper
Install correctly
Replace
Tighten to prescribed driv-
ing torque
Replace
Bleed the circuit
Replace
Replace
Disassemble and clean
Tighten to prescribed driv-
ing torque
Replace
Change the pumping ele-
ment and/or body
Release 00/2001-05 - - - - - - - - - -
0-
7
-00