Wheel Reassembly - APRILIA SL Mille Workshop Manual

SL mille
CHASSIS
o
o
Before proceeding with the reassembly,
that support plate (1) of the brake caliper is posi-
0
tioned correctly; the plate slot must be inserted in the
appropriate stop pin (3) in the inner part of the rear
fork right rod.
Insert the disc in the brake caliper carefully.
When reassembling, take care not to damage the
hose, disc, brake pads and speed sensor cable.
7.3.5 WHEEL REASSEMBLY
Carefully read 0.4.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
• Spread
a.
film oflubricatinq grease on thewholelenqth
of the wheel pin (4), see 1.6 (LUBRICANT CHART).
• Position the right (5) and left (6) chain tighteners in their
seats on the rear fork arms.
• Position the wheel between the rear fork rods on the
support (7).
• Make the wheel advance and ·position the drive chain
(8) on the crown gear (9).
Danger of injury.
Do not introduce your fingers to align the holes.
• Move the wheel backwards, until its central hole and
the holes on the rear fork are aligned.
• Rotate the support plate (1), complete with brake cali-
per (2) and with fulcrum on the stop pin (3), until it is
aligned with the holes.
• Introduce the wheel pin (4) completely from the left
side.
NOTE
Make sure that the wheel pin (4) is inserted
completely, with the head in the appropriate seat on the
left chain tightener (6).
• Position the washer and tighten the nut (10) manually.
• Check the chain tension, see 2.35.3 (ADJUSTING THE
DRIVING CHAIN).
• Tighten the nut (10).
Rear wheel nut driving torque: 120 Nm (12.0 kgm).
After reassembly, pull the rear brake lever repeatedly
and check the correct functioning of the braking sys-
tem.
Check the wheel centering.
Release 00/2001-05 - - - - - - - - - -
11-
49 -
00