APRILIA SL Mille Workshop Manual page 242

SL mille
Follow~
HT coil screw driving torque: 6 Nm (0.6 kgm).
• Unscrew and remove the two screws (12).
• Partially remove the inner HT coil (13).
• Release the pipes (14) from the special clamp (15).
Voltage regulator screws driving torque: 10 Nm (1.0
kgm).
• Unscrew and remove the two screws (16) and remove
the voltage regulator (17).
Saddle support front screws driving torque: 50 Nm
(5.0 kgm). '
• Unscrew and remove the screw (18), taking the nut.
• Unscrew and remove the screw (19).
• Remove the saddle support (20), sliding it off the back.
Where necessary, remove the components attached to
the saddle support (18), i.e.:
Start relay support screw driving torque: 10 Nm (1.0
kgm).
• Unscrew and remove the screw (21).
• Remove the start relay support (22).
Ignition coils support screws driving torque: 10 Nm
(1.0 kgm).
• Unscrew and remove the two screws (23), taking the
washers.
• Remove the relay support (24).
Relay support screws driving torque: 10 Nm (1 kgm).
• Uns.crew and remove the two screws (25), taking the
bushing.
• Remove the relay support (26).
• Remove the passenger seat lock, see 7.1.34 (REMOV-
ING THE PASSENGER SEAT LOCK).
• Remove the passenger footrest supports, see 7.1 .40
(REMOVING THE PASSENGER FOOTREST SUP-
PORTS).
• Remove the fuel tank support rod
mil.
CHASSIS
fiB\-
~"
~-
...
-
.......
_-
..
-
1. . . ' -
-~-
.
r
/~ $~ ~
.
Release 00/2001-05 - - - - - - - - - -
11-
37 -
00