Taylor C708 Operator's Manual page 59

Problem
13.Excessive mix leakage
into the long drip pan.
14.The driveshaft is stuck
in the drive coupling.
15.The freezing cylinder
walls are scored.
16.The product makes a
popping sound when
drawn.
Troubleshooting Guide
Probable Cause
a. Driveshaft seal improperly
lubricated or worn.
b. Driveshaft seal is installed 
inside-out.
c. Inadequate lubrication of the
driveshaft.
d. The driveshaft and beater
assembly work forward.
e. Worn rear shell bearing.
f. Gearbox out of alignment.
a. Mix and lubricant collected in drive
coupling.
b. Rounded corners of driveshaft,
drive coupling, or both.
c. Gearbox is out of alignment.
a. Missing or worn front bearing and
beater shoes.
b. Scraper blades are damaged.
c. Machine was placed in Auto before
all sanitizing solution was removed
from freezing cylinder.
d. Broken freezer door baffle rod.
e. Broken beater pins.
f. Beater assembly is bent.
g. Machine was placed in Auto before
all sanitizing solution was removed
from freezing cylinder.
h. Gearbox is out of alignment.
a. Draw rate is set too fast.
b. Pump assembled incorrectly.
c. Freezing cylinder not primed
correctly.
Models C708 & C716
TROUBLESHOOTING GUIDE
Remedy
a. Lubricate properly or replace the seal.
b. Install correctly.
c. Lubricate properly.
d. Call an authorized service technician.
e. Call an authorized service technician.
f. Call an authorized service technician.
a. Brush-clean the rear shell bearing
area regularly.
b. Call an authorized service technician.
c. Call an authorized service technician.
a. Install or replace the front bearing and
beater shoes.
b. Replace scraper blades.
c. Place machine in Auto only after
priming is complete and all sanitizing
solution is removed.
d. Replace freezer door.
e. Replace beater assembly.
f. Replace beater assembly.
g. Place machine in Auto only after
priming is complete and all sanitizing
solution is removed.
h. Call an authorized service technician.
a. Adjust draw rate of 5 oz. to 7-1/2 oz.
(142 g to 213 g) of product by weight
in 10 seconds.
b. Assemble and lubricate according to
instructions in this manual.
c. Drain the freezing cylinder and 
reprime the machine.
Page
Ref.
6-1
6-1
6-1
- - -
- - -
- - -
6-15
- - -
- - -
6-2,6-4
6-2
6-9/6-10
6-4
6-2
6-2
6-9/6-10
- - -
5-3
6-6
8
6-10
8-3