Taylor C708 Operator's Manual page 12

SAFETY
• If the supply cord is damaged, it must be
replaced by the manufacturer, service agent, or
a similarly qualified person, in order to avoid a
hazard.
WARNING! Avoid injury.
• DO NOT allow untrained personnel to operate
this machine.
• DO NOT operate the machine unless all service
panels and access doors are restrained with
screws.
• DO NOT remove any internal operating parts
(examples: machine door, beater, scraper
3
blades, etc.) unless all control switches are in
the OFF position.
Failure to follow these instructions may result in severe
personal injury, especially to fingers or hands, from
hazardous moving parts.
WARNING! This machine has many sharp
edges that can cause severe injuries.
• DO NOT put objects or fingers in the door
spout. This may contaminate the product and
cause severe personal injury from blade
contact.
• Use extreme caution when removing the
beater assembly. The scraper blades are very
sharp.
• Handling Sharp Edges: Two people are
required to handle the cup/cone dispenser.
Protective gloves must be worn and the
mounting holes must NOT be used to lift or hold
the dispenser. Failure to follow this instruction
can result in personal injury to fingers or
equipment damage.
IMPORTANT! Access to the service area of
the machine is restricted to persons having knowledge
and practical experience with the machine, in particular
as far as safety and hygiene are concerned.
3-2
CAUTION! This machine must be placed on a
level surface. Failure to comply may result in personal
injury or machine damage.
NOTICE! Cleaning and sanitizing schedules
are governed by your federal, state, or local regulatory
agencies and must be followed accordingly. Please see
the cleaning section of this manual for the proper
procedure to clean this machine.
CAUTION! This machine is designed to
maintain product temperature under 41°F (5C). Any
product being added to this machine must be below 41F
(5C). Failure to follow this instruction may result in
health hazards and poor machine performance.
Do not run the machine without product. Failure to follow
this instruction can result in damage to the machine.
Do not obstruct air intake and discharge openings:
C708: A minimum of 6 in. (152 mm) airspace is required
on both sides and 0 in. (0 mm) on the rear.
C716: A minimum of 3 in. (76 mm) airspace is required
on all sides. Install the deflector provided to prevent
recirculation of warm air.
Failure to follow these instructions may cause poor
freezer performance and damage to the machines.
For Indoor Use Only: This machine is designed to
operate indoors under normal ambient temperatures of
70°F to 75°F (21°C to 24°C). The machine has
successfully performed in high ambient temperatures of
up to 104°F (40°C) at reduced capacities.
Noise Level: Airborne noise emission does not exceed
78 dB(A) when measured at a distance of 39 in. (1.0 m)
from the surface of the machine and at a height of 62 in. 
(1.6 m) from the floor.
Models C708 & C716
Safety