Taylor C708 Operator's Manual page 43

Figure 6-17
4. Insert the baffle rods through the beaters in the
freezing cylinders. With the door seated on the
freezer studs, install the handscrews with the longer
ones on top. Tighten equally in a crisscross pattern to
ensure the door is secured.
Figure 6-18
5. Slide the three O-rings into the grooves of each
standard draw valve. Slide the H-ring and O-rings
into the grooves of the center draw valve. Lubricate
the H-ring and O-rings.
Apply the appropriate
Taylor approved food safe lubricant.
Figure 6-19
Operating Procedures
6. Lubricate the inside of the freezer door spouts, top
101529
and bottom.
Apply the appropriate
Taylor approved food safe lubricant.
7. Insert the draw valves from the bottom until the slot in
each draw valve comes into view.
10509
8. Position each draw handle with the adjustment screw
facing down. Slide the fork of each draw handle into
the slot of each draw valve, starting from the right.
9. Slide the pivot pin through the draw handles as the
handles are inserted into the draw valves.
Models C708 & C716
OPERATING PROCEDURES
Apply the appropriate
Taylor approved food safe lubricant.
Figure 6-20
Figure 6-21
Figure 6-22
10508
6
10517
6-5