Taylor C708 Operator's Manual page 45

4. Insert the piston into the retaining pin hole end of the
pump cylinder. (See Figure 6-27.)
Figure 6-27
5. Assemble the valve cap. Slide the O-ring into the
groove of the valve cap. Do not lubricate the O-ring.
(See Figure 6-28.)
Figure 6-28
6. Slide the pump valve gasket into the holes on the
cap. Do not lubricate the gasket. (See Figure 6-29.)
Figure 6-29
Operating Procedures
7. Insert the valve body cap into the hole in the mix inlet
adapter. (See Figure 6-30.)
15123
8. Insert the mix inlet assembly into the pump cylinder.
(See Figure 6-31.)
15109
The adapter must be positioned into the notch
located at the end of the pump cylinder.
9. Secure the pump parts in position by sliding the
retaining pin through the cross holes located at one
15110
end of the pump cylinder. (See Figure 6-32.)
Note: The head of the retaining pin should be
located at the top of the pump when installed.
Models C708 & C716
OPERATING PROCEDURES
Figure 6-30
Figure 6-31
Figure 6-32
15111
15112
6
15194
6-7