Taylor C708 Operator's Manual page 52

OPERATING PROCEDURES
Note: Do not brush-clean the mix inlet hole while
the machine is in the Wash mode.
2. With a pail beneath the door spout(s), open the draw
valve and press the Wash key
(See Figure 6-52.)
3. Drain all the rinse water from the door spout. Close
the draw valve and press the Wash key,
canceling the Wash mode.
4. Repeat this procedure using clean, warm water, until
the water being discharged is clear.
Repeat steps 1 through 4 for the other side of the Model
C716.
6
Hopper Cleaning
1. Prepare an approved 100 PPM cleaning solution
(examples: 2-1/2 gal. [9.5 L] of Kay-5
[7.6 L] of Stera-Sheen
Important! Use warm water and follow the
manufacturer's specifications.
2. Pour the solution into the hopper and allow it to flow
into the freezing cylinder.
3. Using the white hopper brush, clean the mix hopper,
mix-level sensing probes, and the outside of the
agitator driveshaft housing. Using the double-ended
brush, clean the mix inlet hole. (Note: Do not
brush-clean the mix inlet hole while the machine is in
the Wash mode.)
6-14
. 
Figure 6-52
or 2 gal. 
®
®
).

4. Press the Wash key
cleaning solution in the freezing cylinder to come in
contact with all areas of the freezing cylinder.
5. Place an empty pail beneath the door spout(s).
6. Open the draw valve on the freezer door and draw off
all the solution.
13722
7. Once the cleaning solution stops flowing from the
door spout, close the draw valve and press the Wash
key , canceling the Wash mode.
Repeat steps 1 through 7 on the other side of the Model
C716.
Disassembly
Note: Failure to remove the parts specified below for
brush-cleaning and lubrication will result in damage to
the machine. These parts must be removed within the
maximum number of days allowed between brush-clean
cycles or the machine will hard lock and will not operate.
WARNING! Make sure the power switch is in
the OFF position. Failure to follow this instruction may
result in severe personal injury from hazardous moving
parts.
1. Remove the handscrews, freezer door, beater,
scraper blades, and driveshaft with driveshaft seal
from the freezing cylinder.
2. Remove the driveshaft seal from the driveshaft.
3. Remove the retaining pin, mix inlet adaptor, valve
cap, pump gasket, and piston from the pump
cylinder. Remove the O-ring from the piston and
valve cap.
4. Remove the freezer door gasket, front bearing, pivot
pin, draw handle, and draw valve. Remove the three

O-rings from the draw valve.
Note: Remove the design caps (C716 only).
Models C708 & C716
. This will cause the
Operating Procedures