YUNEEC H920 PLUS User Manual page 26

1. When a POI/Point of Interest is set, all waypoints will point to the POI in pan
direction. The custom value will be the angle that the waypoint point to the POI in
pan direction. All single waypoints in pan mode will point to the POI automatically.
2. When no POI is set, all single waypoint in pan mode will be custom value by
default.
3. Custom value in pan direction: The value shows the angle that gimbal points to
the north in pan direction. When the value shows 0°, it means the gimbal pan
direction points to the north. The angle ranges from 0° to 359°. When the angle is
larger, the gimbal pan direction will rotate more in clockwise direction. The custom
value will remain the last setting angle.
2）Tilt
Point to the POI (only when the Custom Waypoint gimbal pan mode is selected in
Global Settings): The gimbal will tilt and automatically point the camera lens to the
POI.
Manual: The operation identical to the gimbal tilt control in angle mode. The left
slider on the ST16 controls gimbal tilt angle. The control range operates from 0° to
-90°.
Custom: At each waypoint, the tilt angle ranges from -90° to 0°. The custom angle
will record the last angle setting.
NOTICE: When single waypoint focuses POI in pan and tilt modes, the camera will
point to the POI automatically. The pilot can also switch to custom mode to trim the
angle to adjust the frame composition.
NOTICE: If a waypoint global setting or POI are not set, the pan and tilt modes of
waypoints both show custom values by default. The default custom value of single
waypoint in pan and tilt modes is 0°.
4. Add action
Multiple actions can be added to any waypoint, including Hover, Pan 360°, or
Record/ Take Photo. Each single point may a maximum of five (5) points.
Connecting drone... H:N/A V.S:N/A
1 2 3 4
2
4
1
3
H.S:N/A D:N/A
5
5
25
Way Point XX
Focus POI Custom
Custom 0°
－
Tilt
Focus POI Manual Custom
Custom 0°
－
Action
Add Action
°
Hover Pan360 Take photo Recond
NO YES
＋
＋