YUNEEC H920 PLUS User Manual page 30

NOTICE: When setting the altitude of the geo-fence, it is strongly recommended to
set the altitude higher than the H920 PLUS's current altitude. The altitude of the
geo-fence should be more than 2m/6.6' for safe operation of the H920 PLUS.
NOTICE: The geo-fence task will not automatically disable when the battery voltage
is low. By selecting the [ ] icon and slide to confirm will disable geo-fence
function.
NOTICE: If the ST16 is in Smart Mode after the geo-fence is activated, the H920
PLUS can fly beyond the geo-fence lines. When flying within the geo-fence in Home
mode, the H920 PLUS will be allowed to fly back to home point when the home point
is out of the geo-fence. The H920 PLUS is still within the geo-fence function. This
means that if the pilot switches the ST16 from Home Mode to Angle mode while the
H920 PLUS is inside the geo-fence, the aircraft will not fly beyond the geo-fence
line.
NOTICE: Exit the geo-fence function by tapping the exit icon [ ] and sliding the
sliding block.
TAKEOFF/POINT-TO-LAND
Press and hold the start/stop button until the propellers begin to spin. Press the
[ ] icon and slide the sliding block. The aircraft will climb to the altitude of
5m/16.4 feet and hover/loiter. The [ ] icon will become a Point-to-Land [ ]
icon. Select and tap on the screen at the desired landing point.
NOTICE: When the altitude of the aircraft is lower than 10m/32.8', it will climb to
10m/32.8' vertically first, then fly to the point at 10m/32.8and descend vertically
within 4-8m/13-26' of the point until it lands automatically. When the flight
altitude of the aircraft is higher than 10m/32.8 feet, it will fly to the point at the
current altitude, then descend vertically within 4-8m/13-26' of the point until it
lands automatically. The icon [ ] will display over the map. Tap the start icon
[ ] and slide the sliding block. The H920 PLUS will execute the point-to-land
function.
NOTICE:The pilot may exit the point-to-land function by switching modes or
choosing [ ] , and then sliding the sliding block.
NOTICE: Joysticks are disabled when the aircraft is executing the Point-to-Land
task.
NOTICE: Prior to exiting the waypoint interface, ensure no task is waiting to be
executed. Press the return button on the controller and slide the sliding block to
exit the waypoint interface.
29