YUNEEC H920 PLUS User Manual page 25

OPERATING WAYPOINT FUNCTION
STEP 1) Press and hold the Start/Stop button to start the motors.
STEP 2) Press [
automatically fly along the mission route as pre-set. Press the [
sliding block; flight will be paused.
NOTICE: After the mission is set, press the icon [
'YES'. After the 'Save Success' message appears, the mission has been successfully
saved. If the pilot needs any previously saved mission, press the icon [
the desired mission.
STEP 3) Press the icon [
through switching into flight mode.
NOTICE: If the H920 PLUS indicates a first level low voltage battery warning during
the waypoint task, waypoint tasks will be automatically ignored, and no other
waypoint task may be set.
OPERATION FOR A SINGLE WAYPOINT MISSION
After the mission route is set using the map, the system will automatically display
several mission waypoints. Press any waypoint on the mission, or any figure on the
top left of the screen. The mission may be configured for a single waypoint.
Settings for single waypoint:
1. Relative altitude (minimum altitude is 16.4 ft./5m, default altitude is 65.6 ft./ 20m)
2. Speed (range from .9KhH/0.06 mph to 30KmH/18.6 mph, default speed is 14.3KmH/8.9
mph)
3. Settings for Gimbal Control in Pan and Tilt Directions
Condition
A
B
C
1）Pan
Follow Airline: The pan direction of the gimbal will follow airline/mission line. It will
move per the direction of the H920 PLUS nose.
Manual: Switch S2 controls Pan Mode of the gimbal and Knob K1 controls Pan
direction of the gimbal.
Custom: In global setting, when pan mode is in custom, it will offer two choices in
single waypoint pan mode.
NOTICE: Pan controlling operation is identical to pan controlling the camera gimbal
in Angle mode.
] icon and then slide the pop up sliding block. The H920 PLUS will
], to exit the task. Another way to quickly exit the task is
Different Conditions for the Gimbal Control
Pan for
Way Point
Global Settings
Follow Airline
Manual
Custom
]. Input the route name and press
Tilt for
Pan for Single
Way Point
Waypoint
Global Settings
Manual,
None
Custom
Manual,
None
Custom
Focus POI, Focus POI,
Manual, Custom
Custom
24
] and slide the
] and select
Tilt for Single
Waypoint
Manual,
Custom
Manual,
Custom
Focus POI,
Manual,
Custom