Retracting And Lowering The Retractable Landing Gear - YUNEEC H920 PLUS User Manual

ANGLE MODE
If the Flight Mode selection switch is in the centre position, then the H920 Plus is in
Angle Mode. Angle Mode is designed for pilots with a little experience (those who
have already mastered Smart Mode), because in this mode the H920 Plus moves in line
with the joystick, in the direction in which the nose is pointed.
To take off/launch, first start the motors in angle mode, then slowly raise the left-hand
stick to slightly above the center position. The H920 PLUS will take off and climb
slowly (push the stick further upward if the H920 doesn't take off). Release the stick to
return to the center position when the H920 PLUS reaches the desired altitude. The
H920 should hover in place.
EXTRA ANGLE MODE FEATURES:
POSITION FREELY AND RETAIN ALTITUDE
The H920 PLUS will hold its position automatically when GPS is enabled (if there is
sufficient GPS signal) and it will retain the altitude level if the left stick is in the middle
position.
WARNING: If the H920 PLUS has not been mastered in Angle Mode, accidents or "fly
away" may result.
IMPORTANT NOTE: Accidental damage and "fly aways" are not covered by the
warranty.

RETRACTING AND LOWERING THE RETRACTABLE LANDING GEAR

The H920 PLUS's landing gear is to keep it out of frame when a camera is attached.
Landing gear may be retracted by switching up the Landing Gear Switch on the top
right side of the ST16. Be certain to flip the switch to the downward position when
landing.
IMPORTANT NOTE: Always put the landing gear in the down position before landing
H920 Plus and before the flight height reaches 3m (10 feet).
IMPORTANT NOTE: The joystick with the two control sticks respond proportionately,
that means that the further you move the control stick from the centered resting point in the
middle in one direction, the stronger the response and the faster the change in course.
IMPORTANT NOTE: The maximum altitude is restricted to 122m/400' above the
ground in Smart Mode and 122m/400'in Angle Mode. If at any time during the H920
14