Preparing To Fly; Flying - YUNEEC H920 PLUS User Manual

PREPARING TO FLY

WARNING: Always operate the H920 PLUS in open areas (approximately 10,000
square feet/930 square meters or more) that are free from people, vehicles, trees and
other obstructions. Never fly near or above crowds, airports or buildings. Obey local
regulations at all times.
Never attempt to operate H920 PLUS nearby tall buildings/obstructions that do not
offer a clear view of the sky (a minimum clearance of 33m/100').
Be sure to place the H920 PLUS on a level and stable surface before powering ON the
ST16 Ground Station and the H920 PLUS Aircraft.
Step back approximately 26 ft (8 m) behind the H920 Plus

FLYING

POWERING ON/OFF
NOTICE: ALWAYS turn on the ST16 and allow it to boot up prior to powering the H920
PLUS (and ALWAYS turn off/power down the H920 PLUS prior to turning off the ST16).
If the main LED status indicator flashes yellow, the compass calibration procedure will
need to be executed. If the main LED status indicator is flashing blue, double check
that the ST16 is powered on and set to the
correct model memory. If the main LED
status indicator is still flashing blue, re-bind
the aircraft to the ST16.
STARTING/STOPPING THE MOTORS
Step back approximately 26 feet (8 meters) behind the H920 Plus.
Press and hold the START/STOP button for about 3 seconds to
start, and about 2 seconds to stop the motors.
NOTICE: If the motors can't be started in such cases of
compass error, insufficient GPS signal with GPS on, or in
home mode, start the motors in angle mode.
32