YUNEEC H920 PLUS User Manual page 19

After sliding the icon, the remote control interface will display EXIT and [
the icon will become [
[ ] will become [
by tapping EXIT icon or switching flight mode.
NOTICE: When the Journey function is activated, the Journey distance may be set by the
pilot.
NOTICE: The gimbal camera cannot be controlled when journey function is activated and
will remain the previous angle set before. Depending on the camera tilt, the H920 PLUSwill
fly up and out to take the perfect self-shot, or "selfie".
NOTICE: The journey route is the reverse direction to which the gimbal camera is facing.
ORBIT ME: When Orbit Me is enabled, H920 Plus flies a circular path around the pilot.
Press ORBIT to enter the ORBIT ME function.
START: Press START, and slide the icon, push the aileron stick to the right or left. The H920
PLUS will fly around the pilot/ST16 with the distance between the start point and the pilot as
the radius.
BACK: Tap BACK to return to the previous interface.
[ ]: When the pilot tap the [
be paused. When tapped again, the [ ] will become [ ], the copter will continue the ORBIT
ME function. Exit the function by tapping EXIT icon or switching flight mode.
NOTICE: You can increase/decrease radius by apply forward/back on right stick.
You also can trim the gimbal pan position by adjusting pan control knob on ST16 under
Follow or Follow controllable mode in Pan direction..
NOTICE: The tilt direction of gimbal camera can be adjusted by the camera tilt control knob.
NOTICE: If the aircraft flies too close to the pilot, it will automatically enlarge the distance and
then begin to orbit.
NOTICE: Adjust the Throttle Control joystick to change the height of the aircraft, adjust the
Aileron Control joystick to change the orbit direction of the aircraft.
1/3
]. Then the journey function will be paused. When tapped again, the
], the H920 PLUS will continue the Journey function. Exit the function
]， the icon will become [ ]and the ORBIT ME function will
18
2
]. Tap the [ ]，